Hirschmann EAGLE 20 - Page 39

Example
RM CLI EAGLE 20
Release 4.3 09/08
3.3 Properties of the CLI
39
 After “login timeout ssh” enter the value desired, in this case 120, to
set the timeout to 120 minutes.
 Execute the command by pressing the <Enter> key.
 Checking the execution with the Show command
 Enter “show” to display all the possible show commands.
 Then enter “login” to display your current login settings.
!(Hirschmann Eagle) #login timeout ssh ?
<1..120> Enter a number in the given range.
!(Hirschmann Eagle) #login timeout ssh 120
(Hirschmann Eagle) (config)#show
authentication Display ordered methods for authentication lists.
config Show configuration.
denial-of-service Show denial-of-service parameters.
device-status Show the device status settings and the current
device status itself.
dhcp-relay Show DHCP Relay parameters.
dhcp-server Show DHCP Server parameters.
interfaces Show interface parameters.
lldp Show the LLDP information.
logging Display logging parameters.
login Show login parameters.
nat Display the NAT settings.
network Show network data.
packet-filter Show the packet-filter configuration.
redundancy Show the redundancy settings.
running-config Show the currently running configuration.
signal-contact Display Signal Contact settings.
snmptraps Display SNMPv3 traps.
sntp Show SNTP configuration parameters and information.
system Show system related items.
temperature Show temperature limits.
user-firewall Show the user firewall settings.
users Display users and user accounts information.
vpn Show VPN settings.