22
Installation MACH 1040
Release
04
10/2015
1.4 Gigabit combo port
The MACH 1040 device provides 16 combo ports for transmission speeds of
up to 1000 Mbit/s.
You have the option of alternatively connecting a twisted pair cable via a
RJ45 socket or an optical fiber via a SFP transceiver to a combo port.
(see figure 1 to figure 4)
By inserting a SFP transceiver, you deactivate automatically the
corresponding twisted pair interface.
Use only Hirschmann SFP transceivers which are suitable for usage with the
device.
See “Accessories” on page 51.
You find information on pin assigments for making patch cables here:
“Pin assignments” on page 23
1.4.1 10/100/1000 Mbit/s twisted pair port
This port is an RJ45 socket.
The 10/100/1000 Mbit/s twisted pair port offers you the ability to connect
network components according to the IEEE 802.3 10BASE-T/100BASE-
TX/1000BASE-T standard.
The MAR1042 and MAR1142 devices also allow:
IEEE 802.3af (Power over Ethernet on data lines).
This port supports:
Autonegotiation
Autopolarity
Autocrossing (if autonegotiation is activated)
1000 Mbit/s full duplex
100 Mbit/s half-duplex mode, 100 Mbit/s full duplex mode
10 Mbit/s half-duplex mode, 10 Mbit/s full duplex mode
Also for MAR1042 and MAR1142:
Power over Ethernet (PoE) at the first 4 ports of the device
The PoE power is supplied via the wire pairs transmitting the signal
(phantom voltage).
Delivery state: Autonegotiation activated
The socket housing is electrically connected with the front panel.
The pin assignment corresponds to MDI-X.
To Next Page
Loading...
