Installation RSP 20/25/30/35
Release
15
12/2017
25
1.5 Ethernet ports
You can connect end devices and other segments to the device ports using
twisted pair cables or optical fibers (F/O).
1.5.1 10/100 Mbit/s twisted pair port
This port is an RJ45 socket.
The 10/100 Mbit/s twisted pair port allows you to connect network
components according to the IEEE 802.3 10BASE-T/100BASE-TX standard.
This port supports:
Autonegotiation
Autopolarity
Autocrossing (if autonegotiation is activated)
100 Mbit/s half-duplex mode, 100 Mbit/s full duplex mode
10 Mbit/s half-duplex mode, 10 Mbit/s full duplex mode
Delivery state: Autonegotiation activated
The port casing is electrically connected to the front panel.
1.5.2 100/1000 Mbit/s twisted pair port (optional)
This port is an SFP slot.
The 100/1000-Mbit/s twisted pair port offers you the possibility to connect
network components according to the IEEE 802.3 100BASE-FX/1000BASE-
SX/1000BASE-LX standard.
This port supports:
1000 Mbit/s full duplex
100 Mbit/s, full duplex
Autonegotiation when using a Gigabit Ethernet SFP transceiver
State on delivery:
1000 Mbit/s full duplex when using a Gigabit Ethernet SFP transceiver
Autonegotiation activated when using a Gigabit Ethernet SFP transceiver
100 Mbit/s full duplex when using a Fast Ethernet SFP transceiver
1.5.3 100 Mbit/s F/O port
This port is an SFP slot.
The 100 Mbit/s F/O port allows you to connect network components
according to the IEEE 802.3 100BASE-FX standard.
This port supports:
100 Mbit/s half-duplex mode, 100 Mbit/s full duplex mode
Default setting: Full duplex
To Next Page
Loading...
Need help?
General
