Installation RSPE 30/32/35/37
Release
12
10/2015
35
2Installation
The devices have been developed for practical application in a harsh
industrial environment.
On delivery, the device is ready for operation.
Perform the following steps to install and configure the device:
Checking the package contents
Installing the SD card (optional)
Mounting a dummy panel or a media module
Installing and grounding the device
Installing an SFP transceiver (optional)
Connecting the terminal blocks
Operating the device
Connecting data cables
Filling out the inscription label
2.1 Checking the package contents
Proceed as follows:
Check whether the package includes all items named in the section
“Scope of delivery” on page 62.
Check the individual parts for transport damage.
2.2 Installing the SD card (optional)
Note: Only use the AutoConfiguration Adapter ACA31 storage medium.
See “Accessories” on page 63.
Proceed as follows:
Deactivate the write protection on the SD card by pushing the write-
protect lock towards the middle of the card.
Push the SD card into the slot with the beveled corner facing upwards.
Tighten the thumb screw hand-tight to fix the SD card.
To Next Page
Loading...
Need help?
General
