Hirschmann RSPE 30 User Manual

42
Installation RSPE 30/32/35/37
Release 12 10/2015
 Always ground the device via the grounding screw.
 Ground the device via the ground screw.
For every supply voltage to be connected, perform the following steps:
 Remove the power connector from the device.
 Connect the protective conductor according to the pin assignment on the
device with the clamp.
 Connect the wires according to the pin assignment on the device with the
clamps.
 Fasten the wires connected by tightening the terminal screws.
With a non-redundant supply of the supply voltage, the device reports the
loss of a supply voltage. You can prevent this message by changing the
configuration in the Management.
WARNING
ELECTRIC SHOCK
Install this device solely in a switch cabinet or in an operating site with
restricted access, to which maintenance staff have exclusive access.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.

Hirschmann RSPE 30 Specifications

General

Brand	Hirschmann
Model	RSPE 30
Category	Switch
Language	English