Installation RSPL 20/30
Release
04
02/2013
27
2 Device installation
The devices have been developed for practical application in a harsh
industrial environment.
On delivery, the device is ready for operation.
The following steps should be performed to install and configure a switch:
Unpacking and checking
Installing the SD card (optional)
Installing the device and grounding
Installing the SFP transceivers (optional)
Connecting the terminal blocks
Mounting the terminal blocks and switching on the supply voltage
Connecting the data lines
Insert data in label area
2.1 Unpacking and checking
Check whether the contents of the package are complete (see page 49
“Scope of delivery”).
Check the individual parts for transport damage.
2.2 Installing the SD card (optional)
Note: The location on the device is described on page 20 “Rear view”.
Only use the AutoConfiguration Adapter ACA31 storage medium.
See “Accessories” on page 49.
Deactivate the write protection on the SD card.
Push the SD card into the slot with the serration facing downwards.
Tighten the knurled screw to ensure that the SD card does not fall out.
To Next Page
Loading...
Need help?
General
