28
Installation RSPL 20/30
Release
04
02/2013
2.3 Installing the device and grounding
2.3.1 Mounting on the DIN rail
Figure 4: Mounting on the DIN rail
Note: Make sure there is at least 10 cm of space above and below the
device.
WARNING
FIRE HAZARD
Install the device in a fire protected enclosure according to EN 60950-1.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.
WARNING
Only for device variants with operating voltage type M9:
ELECTRIC SHOCK
Only install this device in a switch cabinet or in an operating site with limited
access, to which only maintenance staff have access.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.
To Next Page
Loading...
Need help?
General
