Installation RSPL 20/30
Release
04
02/2013
35
3 Basic set-up
The IP parameters must be entered when the device is installed for the first
time. The device provides the following options for configuring IP addresses:
Entry via V.24 connection
Entry using the HiDiscovery protocol via the application HiDiscovery or
Industrial HiVision
Configuration via BOOTP
Configuration via DHCP (Option 82)
AutoConfiguration Adapter
Further information on the basic settings of the device can be found in the
user manual on the CD/DVD.
Default settings
IP address: The device looks for the IP address using DHCP
Management password:
user, password: public (read only)
admin, password: private (read/write)
V.24 data rate: 9,600 Baud
Ethernet ports: link status is not evaluated (signal contact)
Optical ports: Full duplex
TP ports: Autonegotiation
RSTP (Rapid Spanning Tree) activated
To Next Page
Loading...
Need help?
General
