Menu
2.4
Using the Channel Menu
Auto Scan
Automatically scan for channels to view programming from your TV source.
• Reception: Satellite
You can set the Operator, Satellite Mode, Mode setup.
• Reception: Cable
Operator: You can select UNITYMEDIA, TELECOLUMBUS or Others.
Channel: You can select All Channels or Free Channels.
Scan Mode: You can select
ATV, DTV or ATV+DTV.
Search Mode: You can select Frequency Scan or Quick Scan.
Network ID: You can select auto or 0
(If you select 0, you can manually enter the network
ID, click Save).
LCN: You can select on or off. (Only available in certain countries)
• Reception: Antenna
Scan Mode: You can select
ATV, DTV or ATV+DTV.
Channel: You can select All channels or Free channels.
LCN: You can select on or off. (Only available in certain countries)
DTV Manual
Scan
Allows you to make manual fine tuning adjustments of the channel under DTV mode.
When the DTV Manual Scan screen appears, press the [< / >] buttons to select
Antenna, Cable or Satellite and then set the corresponding parameter. Press the
Search to commence the search of that channel. When the signal has been tuned,
signal strength will be displayed on the screen.
ATV Manual
Scan
Allows you to make manual fine tuning adjustments if the channel reception is poor under
ATV mode.
• Tuner Mode:
You can select
Antenna or Cable
.
• Frequency: Input the channel frequency which you desired.
• Picture System: Select the Colour System: Auto, SECAM, PAL, NTSC.
• Sound System: Select the sound system: B/G, D/K, L, L’, M, I.
Setup
Picture
Sound
Channel
Network
System
About
Auto Scan
DTV Manual Scan
ATV Manual Scan
Channel Edit
Channel list auto-update
Advanced Settings
Parental Controls
To Next Page
Loading...
Need help?
General
