Hisense HER30F5CSS - Troubleshooting Guide; Oven Troubleshooting Continued; Information Codes and Solutions

26
The oven controls
have been set
incorrectly.
See the section on
self-cleaning on page
19.
A self-cleaning
cycle cannot be
started if the oven
lockout feature has
been activated or if
a radiant surface
element is on.
Deactivate the oven
lockout (see page 19).
Make sure all surface
elements are turned
off.
Excessive
smoking
during a
self-
cleaning
cycle.
There is excessive
soiling in the oven.
Press 0FF. Open the
windows to rid the
room of smoke. Wait
until the self-cleaning
cycle is cancelled.
Wipe up the
excessive soil and
then start the self-
cleaning cycle again.
The oven
door will
not open
after a
self-clea
ning
cycle.
The oven is too hot.
Allow the oven to
cool.
Steam is
coming
out of
the vent.
When using the
convection feature,
it is normal to see
steam coming out
of the oven vent.
This is normal
operation, and not a
system failure.
Use the range as
usual.
As the number of
racks or amount of
food being cooked
increases, the
amount of visible
steam will
increase.
A
burning
or oily
odor is
coming
from the
vent.
This is normal in a
new oven and will
disappear in time.
To speed the process,
set a self- cleaning
cycle for a minimum
of 3 hours.
See the section on
self-cleaning on page
19.
Strong
odor.
An odor coming
from the insulation
around the inside
of the oven is
normal for the first
few times the
oven is used.
Operate the oven
empty on the bake
setting at 400。F for 1
hour.
Fan
noise.
A convection fan
may automatically
turn on and off.
This is not a system
failure but normal
operation.
Oven
racks are
difficult
to slide.
The shiny,
silver-coloured
racks were cleaned
in a self-cleaning
cycle.
Apply a small amount
of vegetable oil to a
paper towel and wipe
the
edges of the oven
racks with the paper
towel.
The
oven
door is
locked.
The circuit breaker
has been tripped
or there was a
power failure
while the oven
door was locked.
Activate Control
Lockout, and then
unlock the control.
See the Control
Lockout section on
page 18.
(5) Information Code
Oven
Error
code
symbol
Possible cause
Solution
E0
The temperature
sensor PT100 may be
damaged and circuit
Replace the
temperature sensor
PT100.