Hisense HV643D90 User Manual

Remove blockages
Unblocking the drainage pump
If the dishwasher still contains water after the program has finished, something may be blocking the
drainage pump, which results in the Water outlet fault error message.
1.
Turn off the machine using
and remove the plug from the wall socket.
2. Remove the filter.
3. Scoop out the water from the dishwasher tub.
4. In order to inspect the drainage pump, remove the yellow drainage pump stop on the right in the
bottom drain. (Use a pair of pliers if necessary.)
5. Turn the pump wheel located behind the drainage pump stop by hand. Carefully remove any sharp
items, such as glass.
6. Refit the drainage pump stop. Refit the filter.
7. Plug the machine in again.
Drainage pump
stop
NOTE!
Do not forget to refit the drainage pump stop.
Unblocking the inlet hose filter
If the water supply contains small particles, the outer filter on the inlet hose may become blocked,
which results in the Water inlet fault error message.
1.
Turn off the machine using
and remove the plug from the wall socket.
2. Turn off the water tap.
3. Unscrew the inlet hose.
4. Carefully remove the outer filter from the inlet hose and clean it.
5. Refit the filter and check that the gasket is correctly positioned.
6. Screw the inlet hose firmly into place.
7. Plug the machine into the wall socket and turn on the water tap. Allow the pressure to settle for
a while and check that the connection is watertight.
Outer filter on
inlet hose
Gasket
23

Hisense HV643D90 Specifications

General

Door color	Black
Water fill	Cold, Hot
Cord length	1.5 m
Control type	Touch
Display type	LED
Product size	Full size (60 cm)
Tub material	Stainless steel
Number of baskets	3 basket(s)
Custom panel-ready	Yes
Appliance placement	Fully built-in
Cutlery compartment type	Drawer
Baskets adjustable placement	Upper
Half-load	No
Cycle time	221 min
Noise level	45 dB
Drying system	Residual heat
Delay start (max)	24 h
Dishwashing programs	60min, Auto, Eco, Glass/delicate, Hygiene, Intensive
Number of spray zones	4
Number of place settings	16 place settings
Number of washing programs	6
Number of temperature settings	5
Cycle time (quick washing program)	15 min
Country of origin	China
Current	10 A
Connected load	1900 W
Power plug type	Type G
AC input voltage	220-240 V
AC input frequency	50 Hz
Energy efficiency scale	A to G
Power consumption (left-on)	0.49 W
Water consumption per cycle	11 L
Energy consumption per cycle	0.87 kWh
Package depth	682 mm
Package width	656 mm
Package height	889 mm
Package weight	37000 g

Weight and Dimensions

Depth	555 mm
Width	598 mm
Height	816 mm
Weight	32000 g
Installation compartment height (max)	885 mm