Settings Alternatives
A beep confirms that the control panel has been pressed.2 Sounds 00 - 03
A beep indicates when a dishwashing program has
ended.
Error messages are always indicated by a loud buzzer.
3 Rinse aid 00 - 05 Setting for rinse aid dosage. The rinse aid dispenser can
be adjusted between 00 (Off) and 05 (High dosage).
Increase the rinse aid dosage:
• If the dishes have water marks.
Decrease the rinse aid dosage:
• If the dishes have a sticky white/blue film.
• If the dishes are streaked.
• Build-up of foam. If you have very soft water, the
rinse aid can be diluted 50:50 with water.
Pre-selected at factory: 03
4 Water hardness 00 - 07 Adjusting the water softener. Select a setting depending
on the hardness of the water supply. It is important that
this setting is correct!
See Water hardness in the chapter Before washing for
the first time.
For a water supply with a hardness below 2.8°dH (5°fH /
This setting reduces the rinse aid dosage and affects how
often the dishwasher's built-in softener is regenerated.
18
.
2.
To open the dishwasher's settings menu, press and hold
until SEt is shown on the
display.
3.
Press
to step through the settings menu.
4.
Press
to step through the alternatives.
5.
Confirm the selected setting by pressing
.
6.
To exit the menu, step through it or press
.
and
Settings
1.
Press
Confirm / Next setting
Select alternative
Open the dishwasher's settings menu
deactivated and no salt needs to be added.
TAB 00 (Off) Activate this setting when using an all-in-one detergent
01 (On) that contains rinse aid.
3.5°eH / 0.5 mmol/l), select 00. The water softener is
Pre-selected at factory: 04
5
To Next Page
Loading...
