EasyManua.ls Logo

Hisense HV643D90 - Resolving Dish Spots and Film Issues

Hisense HV643D90
35 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Problem Possible causes Action
Dishes loaded incorrectly. Do not cover porcelain with
large bowls or the like. Avoid
placing very tall glasses in the
corners of the baskets. See the
chapter Loading the dishwash-
er.
Glasses and cups have toppled Place dishes to sit steady.
over during the program.
The filter is clogged. Clean the filter.
The filter is not fitted correctly. Check that the filter is fitted
correctly. See the chapter Care
and cleaning.
Check that the yellow drainage
pump stop on the right in the
bottom drain is in place. See the
Drainage pump stop missing.
chapter Care and cleaning.
Some foodstuffs, such as mus- Rinse off these types of food-
stuffs if not starting the dish-
washer immediately. Consider
using 1h 65° with the Speed
wash option.
tard, mayonnaise, lemon, vineg-
Spots on stainless steel or sil-
ver.
ar, salt and dressings, can
cause spots on stainless steel
ifl eft for too long.
All stainless steel can cause In order to avoid marks and tar-
spots on silver if they come into nishing, separate dishes made
contact during dishwashing. from different metals, such as
silver, stainless steel and alu-
minium.
Aluminium can also cause spots
on dishes.
Spots or films on the dishes. Incorrect rinse aid dosage set- See the chapter Settings.
ting.
Switch all-in-one detergents or
deactivate the TAB setting and
top up with salt and separate
rinse aid. See Rinse aid in the
chapter Settings.
The setting TAB is activated and
all-in-one detergent with insuffi-
cient drying effect is being used.
Salt compartment empty. Top up with salt. See the
chapter Before washing for the
first time.
See Water hardness in the
chapter Settings.
Incorrect water softener setting.
The water softener is leaking Check that the salt compart-
salt. ment lid is properly tightened.
Otherwise contact your nearest
service centre.
Too high temperature and/or Wash crystal at a low temperat-
too much detergent can cause ure and with a conservative
etching on crystal. Unfortu- amount of detergent. Contact
nately, this cannot be repaired, the detergent manufacturer.
only prevented.
26

Related product manuals