EasyManua.ls Logo

Hisun HS 250UTV - Driving Checks and Gauge Monitoring; Immediate Engine Stop Conditions; Gauge Monitoring

Hisun HS 250UTV
58 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Introduction HS 200UTV/HS 250UTV
1-29
CHECK DURING DRIVING
Immediately Stop the Engine if
The engine suddenly slows down or
accelerates.
Unusual noises are suddenly heard.
Exhaust fumes suddenly become very
white.
While driving, check the following items to see
if all parts are functioning normally.
[1] Fuel gauge
[2] Coolant temperature gauge
Fuel Gauge
Park the vehicle on a flat place.
Turn the key switch to “On”, the fuel gauge will
indicate the fuel level.
Be careful not to fully empty the fuel tank.
Otherwise air may enter the fuel system.
Coolant Temperature Gauge
CAUTION:
To avoid personal injury:
Do not remove radiator cap until the
coolant temperature is well below its
boiling point. Then loosen cap slightly
to relieve pressure before removing
cap completely.
1. With the key switch “ON” the temperature
gauge indicates the temperature of the
coolant. White Zone for “cold” and Red
zone for “hot”.
2. If the indicator reaches the Red zone, the
engine coolant is overheated. Check the
vehicle by referring to the
“TROUBLESHOOTING” section.
[1] Hour meter
The hour meter indicates in five digits the
hours the vehicle has been used; the last digit
indicates 1/10 of an hour.
The speedometer indicates the traveling speed.

Related product manuals