EasyManua.ls Logo

Hisun HS 250UTV - Adjusting Toe-In; Toe-In Adjustment Procedure; Cleaning Muffler

Hisun HS 250UTV
58 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Introduction HS 200UTV/HS 250UTV
1-43
[1] Battery
1. To slow charge the battery connect the
battery positive terminal to the charger
positive terminal and the negative to the
negative, then recharge in the standard
fashion.
2. A boost charge is only for emergencies it
will partially charge the battery as early as
possible.
3. When exchanging an old battery for a new
one use battery of equal specification
shown in table 1.
Battery type
Volts
GTX9BS
12
Direction for storage
1. When storing the vehicle for a long period,
remove the battery from the vehicle, store
in a dry place out of direct sunlight.
2. The battery will self-discharge while it is
stored; recharge it once every three
months in hot seasons and once every six
months in cold seasons.
Adjusting toe-in
Proper toe-in
0 to12 mm (0 to 0.47 in)
1. Park vehicle on flat place.
2. Turn steering wheel so front wheels are
in the straight ahead position.
3. Lock the park brake and stop the engine.
4. Measure distance between tire beads at
rear of tire at hub height.
5. Front distance should be shorter than
rear distance if not adjust tie rod length.
Adjusting procedures
1. Loosen the lock nut and turn the tie rod
to adjust the rod length until the proper
toe-in measurement is obtained.
2. Retighten the lock nut.
IMPORTANT
Keep the equal length of the left and
right tie-rod.
Cleaning Muffler
CAUTION
To avoid personal injury:
Before touching any part of an
exhaust system, be absolutely sure
that it has sufficient time to cool!
Always wear safety goggles and
facemask.
The particulate matter contained in the
muffler contains chemicals that are
harmful to people, animals and marine
life.
If you are unable to do this work, have
it done by your dealer.

Related product manuals