EasyManua.ls Logo

Hisun HS 250UTV - Intake Air Line Check; Precaution at Overheating; Every 300 Hours; 300-Hour Tire Wear and Replacement

Hisun HS 250UTV
58 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Introduction HS 200UTV/HS 250UTV
1-47
1. If hose clamps are loose or water leaks,
tighten bands securely.
2. Replace hoses and tighten hose clamps
securely, if radiator hoses are swollen,
hardened or cracked. Replace hoses and
hose clamps every 2 years or earlier if
checked and found that hoses are swollen,
hardened or cracked.
[1] Radiator hose [2] Clamp bands
Precaution at Overheating
Take the following actions in the event the
coolant temperature is close to or more than
the boiling point, which is called “Overheating”.
1. Stop the vehicle operation in a safe place
and keep the engine unloaded idling.
2. Don’t stop the engine suddenly, but stop it
after about 5 minutes of unloaded idling.
3. Keep yourself well away from the vehicle
for at least 10 minutes or while the steam is
blowing out.
4. Check to see if there is no danger such as
burning, get rid of the causes of
overheating according to the
“TROUBLESHOOTING” section of the
manual, and then start the engine again.
Checking Intake Air Line
1. Check to see if the hoses and hose
clamps are tight and not damaged.
2. If hoses and clamps are found to be worn
or damaged, replace or repair them at
once.
[1] Hose [2] Hose clamp
EVERY 300 HOURS
Checking Tire
1. Check to see if tires are not damaged.
2. If the tires are cracked, bulged, or cut, or
they are worn out, replace or repair them
at once.
Tire Tread Depth
Always replace the tires when the tread depth
is worn to minimum allowable.
3mm(0.12in)

Related product manuals