Hisun HS 250UTV - Checking Engine Start System; Checking Wheel Bolt Torque

Introduction HS 200UTV/HS 250UTV
1-40
[1] Gear shift lever pivot (spray type grease )
■Checking engine start system
CAUTION
TO avoid personal injury
 Do not allow anyone near the vehicle
while testing.
 If the vehicle does not pass the test, do
not operate the vehicle.
◆Preparation before testing
1. Place all control levers in the “NEUTRAL”
position.
2. Set the parking brake and stop the engine.
◆Test Gear shift range lever safety switch
1. Sit on the operator’s seat.
2. Shift the gear shift range lever to: “L”, “H”,
or REVERSE position.
3. Turn the key to “START” position.
4. The engine must not crank.
5. If it cranks consult your local dealer for this
service.
[1] Brake pedal
[2] Accelerator pedal
■Checking wheel bolt torque
CAUTION
To avoid personal injury
 Never operate vehicle with a loose
wheel bolts.
 Any time these bolts are loosened
they should be retightened to the
specified torque.
 Check all bolts frequently and keep
them tight.
Check wheel bolts regularly especially when
new if they are loose tighten them as
follows:
①Torque wheel bolts to 65 to 78 N.m