Hisun HS 250UTV - Instrument Panel and Safety Device Checks; Instrument Panel Gauge and Lamp Checks; Seat Belt and ROPS Hardware Checks; Every 50 Hours

Introduction HS 200UTV/HS 250UTV
1-39
NOTE
Make sure the parking brake warning lamp on
the display goes off when parking brake lever is
down.
[1] Release button
[2] RELEASE
[3] PULL
■ Checking gauges meter and warning
lamps
1. Inspect the instrument panel for broken
gauges meter and warning lamps.
2. Replace if broken.
■Checking head light turn signal light etc
1. Inspect lights for broken bulbs and lenses
2. Replace if broken
■Checking seat belt and ROPS
1. Always check condition of seat belt and
ROPS attaching hardware before operating
vehicle.
2. Replace if damaged.
■Checking tire inflation pressure
Though the tire pressure is factory-set to the
prescribed level, it naturally drops slowly in
the course of time, thus check it every day
and inflate as necessary.
tire sizes
inflation pressure
Front : 22x7-10
49kPa (0.49kgf/cm
2
,
7psi)
Rear:22x10-10
49kPa (0.49kgf/cm
2
,
7psi)
EVERY 50 HOURS
■Greasing
Apply a small amount of multi-purpose grease
to the following points every 50 hours. If you
operated the vehicle in extremely wet and
muddy conditions lubricate grease fittings
more often.
[1] Parking brake pivot (spray type grease )