Hisun HS 250UTV - Page 58

Introduction HS 200UTV/HS 250UTV
1-58
 High rotary speed for clutch
connection.
 Replace he junior clutch spring;
 Replace the primary clutch.
 Non good adjust for gearshift
stay wire.
 Put the gearshift rod into the
position of “N”.
 Put the gearshift arm of engine
into ”N”.
 Adjust the stay wire and the bolt.
 Lock tightly.
 Gear abrasion
 Replace the gears
Transmission noise
 Big matching clearance for the
inner and outside gears of
transmission shaft
 Replace the gears
 Big clearance of transmission
gears.
 Replace the gears
 Non good connection of gear
end face
 Replace the gears
Less vehicle power
 Parking brake
 Loosen the lay-up rod
 Non full Uncoupling for disc
brake
 Contact the distributor.
 CVT transmission sliding
 Removing the grease for the
clutch.
Replace CVT transmission belt
Replace the clutch.
No brakes or noise
 Less brake fluid
 Check the braking oil level
 Air inside the braking system.
 Contact the distributor.
 Brake discs abrasion
 Contact the distributor.
 Assembling bolt of disc plate
loose
 Lock tightly
 Assembling bolt for disc brake
clippers loose
 Lock tightly
If you have any questions, consult your local dealer.
Consult your local dealer for further details.
1. Roof；
2. Windshield；
3. Windlass
4. Motor Scan KF90121;