--- 22 ---
(1) Remove the M6 x 110 Bolt [8] and M6 x 90 Bolt [11] using a 10 mm wrench, and remove the Saw Blade Guard
and Spreader Assembly (Blade Guard [3] and Spreader [24]).
(2) Remove the two M5 x 8 Machine Screws [59] and remove the Table Insert [58].
(3) Put the 22 mm wrench (standard accessory) on the Spindle Ass'y [201] to hold it. Then, put the 23 mm end of
the 23 x 26 mm wrench (standard accessory) on the Set Nut [99]. Turn it counterclockwise to remove the nut,
and remove Washer (A) [98], the TCT Saw Blade [704] and Washer (A) [98] in this order.
Refer to Fig. 28 for the part numbers of the 200 level.
B. Disassembly of the switch section
Tools required:
• Phillips head screwdriver
Fig. 24
(1) Remove the two D5 x 16 Tapping Screws [155] and remove the Switch plate [158]. Then, detach each lead
wire connected to the Circuit Breaker Switch [152] and Rocker Switch [159].
To Next Page
Loading...
