--- 23 ---
C. Disassembly of the motor and wheel sections
Tools required:
• Phillips head screwdriver
• Flatblade screwdriver
• 3 mm Hexagon bar wrench
• 10 mm and 12 mm Wrenches
• Plastic hammer
Fig. 25
(2) Remove the three D4 x 10 Tapping Screws [150] and remove the Switch Box [147]. Then, remove the two D4
x 8 Pan Hd.Tapping Screws [156] and detach the ground wire (green/yellow).
To Next Page
Loading...
