Hitachi C 10RA2 - Page 29

--- 25 ---
D. Disassembly of the body and spindle sections
Tools required:
• Pillips head screwdriver
• 3 mm Hexagon bar wrench
• 8 mm, 10 mm and 13 mm Wrenches
• Plastic hammer
Fig. 26
(1) Remove the four M6 Nuts [105] using a 10 mm wrench, and remove the Body [92] from the Table [67].
(2) Remove the four M6 x 12 Machine Screws [112], and remove the Bracket [113].
(3) Remove the five D5 x 10 Tapping Screws [100], and remove the Blade Guard [101].
(4) Remove the M6 x 12 Machine Screw [97], and remove the Guard [95].
(5) Hold the Screw Bar [90] using an 8 mm wrench, and remove the M6 Special Nut Chuck [94] with a 10 mm
wrench.
(6) Slide the Bracket [211] upward (in the direction of the arrow in Fig. 26) and loosen the two M6 x 6 Hex. Socket
Set Screws [87]. Remove the M8 x 14.3 Flat Washer [88] and Bevel Gear (B) [89] from the Screw Bar [90].
(7) Remove the four M6 x 35 Bolts [78] using a 10 mm wrench, and remove the Slide Bracket [76] and Bracket
[211].