--- 26 ---
(8) Remove the four M4 x 12 Machine Screws [203], and remove the Bearing Retainer [205].
(9) Remove the Spindle Ass'y [201] by striking the Bracket [211] with a plastic hammer.
(
10
) Hold the Screw Bar [90] using an 8 mm wrench, and remove the M8 Nut Chuck [91] with a 13 mm wrench.
Remove the Screw Bar [90] from the Bracket [211].
(11) Loosen the eight M8 x 20 Bolts (with Washers) [153] which fix Extension Supporter (L) [142] and Extension
Supporter (R) [154] with a 13 mm wrench and remove them.
(
12
) Remove the four M6 x 12 Bolts (with Washers) [122] using a 10 mm wrench, and remove the Body Shell
[123] from the Table [67].
Refer to Fig. 28 for the part numbers of the 200 level.
E. Disassembly of the rip fence section (fence ass'y)
Tools required:
• Phillips head screwdriver
• Pliers
• 5 mm Hexagon bar wrench
Fig. 27
(1) Loosen the two M6 x 16 Hex. Socket Hd. Bolts [40] which fix the Support [35] to the Parallel Bracket [42] with
a 5 mm hexagon bar wrench to remove the Support [35]. Be careful not to make the 57L Compression Spring
[36] fly out of the Support [35].
(2) Extract the Locking Rod [39] together with the 5/16" x 5/8" Flat Washer [37] being careful not to lose it.
(3) Loosen the two M6 x 16 Hex. Socket Hd. Bolts [40] which fix the Width Body [46] to the Parallel Bracket [42]
with a 5 mm hexagon bar wrench to remove the Width Body [46].
(4) Loosen the M5 x 12 Machine Screw [47] and remove the Rubber Stopper [161].
To Next Page
Loading...
