Management LAN port configuration is completed.
Repeat step 7 to step 10 as necessary for switch module 1 to 3.
LAN switch module initial configuration
Create new user ID.
Login
1. Start a terminal emulator to the switch module from the system console,
and then connect IP address configured at Management LAN port
configuration on page 2-14.
2. The system administrator's user ID and password have factory default
values. Input the following user ID and password to login.
Table 2-4 Factory default setting for the system administrator
Item Factory default setting
User ID operator
Password (not set)
Input <operator> as the user ID, and then press Enter.
Initial setup
2-21
Hitachi Compute Blade 500 Series Getting Started Guide
To Next Page
Loading...
