Hitachi Compute Blade 500 Series - Page 47

Tip: The account of <newuser ID> is permitted as the user privilege only,
not administrator.
If you input enable, the user privilege will change to the system
administrator privilege.
Logout
1. Input logout at the prompt, and then press Enter.
User ID confirmation
Confirm whether <newuser ID> has been created correctly. <newuser ID>
is created as User ID creation.
1. Start a terminal emulator to the switch module from the system console.
2. Input <newuser ID>, and then press Enter.
3. Input the defined <password>, and then press Enter.
4. Confirm the following whether the login was successful.
5. Input logout, and then press Enter.
Initial setup
2-23
Hitachi Compute Blade 500 Series Getting Started Guide