Hitachi Compute Blade 500 Series - Page 48

User ID creation for management module
Create a user ID <yyyyyyyy> for the management module to operate the
LAN switch module.
1. Start a terminal emulator to the switch module from the system console.
2. Input <operator>, and then press Enter.
3. Change user mode to administrator mode.
Input enable, and then press Enter.
4. Add a new user ID.
Input adduser <yyyyyyyy>, and then press Enter.
5. Set a password to the user ID.
Input <new password>, and then press Enter.
2-24
Initial setup
Hitachi Compute Blade 500 Series Getting Started Guide