Hitachi Compute Blade 500 Series - Page 50

Authentication settings for management module
Setup authentication to the user ID created inUser ID creation for
management module on page 2-24.
1. Start a web browser on the system console.
2. Enter the URL of management module's web console ("https://
192.168.0.1/" as the factory default) in the navigation bar.
Table 2-5 Factory default settings
Item Factory default
IP address of management module 192.168.0.1
URL of Web console https://192.168.0.1
Tip:
•
The above URL is the default. When you use the default, you can omit
to enter a port number. If you change the IP address of management
module or the port number, enter the URL corresponding to the new
settings.
• The format of URL is as below:
http://< IP address>:< port number> or
https://< IP address>:< port number>
• The default port number:
- http: 80
2-26
Initial setup
Hitachi Compute Blade 500 Series Getting Started Guide