Hitachi Compute Blade 500 Series - Page 57

Table 2-8 Factory default setting
Item Factory default setting
User ID admin
Password password
Input admin as the user ID, and then press Enter.
Input <password>, and then press Enter.
Changing password
Change the password for the admin user ID.
1. Navigate to the system administrator mode, input passwd admin, and
then press Enter.
2. Change the system administrator password, input <old password>, and
then press Enter.
3. Input <new password>, and then press Enter.
4. Input <new password> again for confirmation, and then press Enter.
Initial setup
2-33
Hitachi Compute Blade 500 Series Getting Started Guide