28
CP-WX11000 ( P6WX )
6-5-2 Placing batteries into the remote control
•
Use the batteries included in this product or two new batteries of the specified type: HITACHI MAXELL,
part number LR6 or R6P.
1. Remove the battery cover.
Slide back and remove the battery cover in the direction of the arrow.
2. Insert the batteries.
Align and insert the two AA batteries according to their plus and minus terminals as indicated in the
remote control.
3. Close the battery cover.
Replace the battery cover in the direction of the arrow and snap it back into place.
Changing the frequency of remote control signal
The remote control accessory has the choice of mode 1 or mode
2 in the frequency of its signal. If the remote control does not
function properly, attempt to change the signal frequency. Please
remember that the “REMOTE FREQ.” in SERVICE item of
OPTION menu of the projector to be controlled should be set to
the same mode as the remote control. To set the mode of the
remote control, slide the knob of the frequency switch inside the
battery cover into the position indicated by the mode number to
choose.
Ɣ The Laser pointer
This remote control has a laser pointer. The laser beam works and the LASER
INDICATOR lights while the LASER button is pressed.
WARNING
Use the laser beam of the remote control only for the pointer on the screen. Do not apply the
laser beam to anything except the screen.
• Never hit eyes by the laser beam since the laser beam can injure eyes.
• Do not apply the laser beam to anything except the screen.
21
Back of the
remote control
Inside of
the battery cover
Frequency switch
BLA
NK LASER
FREE
ZE
LA
SER
IND
ICATOR
DIG
ITAL
STAN
DBY/O
N
COM
PUTER
LENS SHIFT
KEYS
TONE
ID 3
ID 4
ID 2
ID 1
VIDEO
AUTO
ASPECT
RESET
MENU
MAGN
IFY
ON
OFF
3
4
ENTER
FOCUS
+
-
POSITI
ON
PbyP
ZOOM
+
-
1
2
MY BU
TTON
MY SO
URCE
SHUT
TER
LASER INDICATOR
LASER button
Laser aperture
To Next Page
Loading...
