Hitachi CP-X8800 - Page 119

119
SHADE
Regarding the indicator lamps
Regarding the indicator lamps (continued)
Indicator Status Description
There is a possibility that the interior portion
has become heated.
Please turn the power off, and allow the projector to
cool down at least 20 minutes. After the projector has
sufciently cooled down, please make conrmation of
the following items, and then turn the power on again.
• Is there blockage of the air passage aperture?
• Is the air lter dirty?
• Please use the unit within the temperature range.
NORMAL MODE: 0 to 40°C
ECO MODE: 0 to 45°C
• Is the setting for ALTITUDE appropriate?
• Is the exhaust air (hot/cold) from peripheral
equipments blowing against the ventilation opening
of projector?
For details on ALTITUDE, refer to ALTITUDE of
SERVICE in the OPTION menu. If the projector is
used with a wrong setting, it may cause damage to
the projector itself or the parts inside.
It is time to clean the air lter.
Please turn the power off immediately, and clean or
change the air lter referring to the section Cleaning
and replacing the air lter. After cleaning or
changing the air lter, please be sure to reset the
lter timer.
After the remedy, restart the projector.
Other error has occured.
• Please use the unit within the temperature range.
NORMAL MODE: 0 to 40°C
ECO MODE: 0 to 45°C
If the same indication is displayed after the remedy,
please contact your dealer or service company.
(continued on next page)
Red
Red Red
SHADE
SHADE
RedRed
Red
Blinking at the
same time
Blinking
alternately
Blinking at the
same time
or