T
Tanya MaloneSep 8, 2025
What to do if my Hitachi CP-X8150 AV MUTE function is working?
- JJennifer FisherSep 9, 2025
If the AV MUTE function is enabled on your Hitachi Projector, press the AV MUTE button on the remote control to disable it.
To Next PageTo Next PageWhat to do if my Hitachi CP-X8150 AV MUTE function is working?
If the AV MUTE function is enabled on your Hitachi Projector, press the AV MUTE button on the remote control to disable it.
What to do when my Hitachi CP-X8150 says it is time to clean the air filter?
If your Hitachi Projector indicates it's time to clean the air filter, immediately turn the power off and clean or change the air filter.
What to do if my Hitachi CP-X8150 lamp is approaching the end of its product lifetime?
Replace the lamp of your Hitachi Projector.
What to do if the same network address is set for both wireless and wired LAN on my Hitachi CP-X8150?
If the same network address is set for both wireless and wired LAN on your Hitachi Projector, change the network address setting for wireless or wired LAN.
What to do if the AUDIO SOURCE/SPEAKER setting is not correct on my Hitachi Projector?
If the AUDIO SOURCE/SPEAKER setting is incorrect on your Hitachi Projector, set the AUDIO SOURCE/SPEAKER correctly in the AUDIO menu.
What to do if The Sound button or checkbox is disabled on my Hitachi CP-X8150?
If the Sound button or checkbox is disabled on your Hitachi Projector, and you have selected USB TYPE A, turn the sound on from the Thumbnail menu.
What to do if my Hitachi Projector has an improper signal input?
If your Hitachi Projector shows an improper signal input, confirm the specifications for your projector or the signal source specifications.
What to do if the batteries in my Hitachi CP-X8150 remote control are near the end?
If the batteries in your Hitachi Projector remote control are low, replace them.
What to do if the SAVING function is working on my Hitachi Projector?
If the SAVING function is active on your Hitachi Projector, select NORMAL for STANDBY MODE item in the SETUP menu.
What to do if the internal temperature is rising in my Hitachi Projector?
If your Hitachi Projector is overheating, turn the power off and allow the projector to cool down for at least 20 minutes.
General| Resolution | XGA (1024 x 768) |
|---|---|
| Contrast Ratio | 2000:1 |
| Projection System | 3LCD |
| Screen Size | 30 - 300 inches |
| Lamp Life | 2000 hours (Normal mode), 3000 hours (Eco mode) |
| Connectivity | VGA, S-Video, USB |
| Zoom Ratio | 1.6x |
| Keystone Correction | Vertical ± 30 degrees |
| Speakers | 10W |
| Power Consumption | 320W (Eco Mode) |
| Noise Level | 37 dB (Normal mode) |
