Hitachi CP-X8150 - Selecting Lamp Operation Mode

15
STACK menu settings
3. Press the ◄ button to return to the previous menu, or press the ► button to
complete the setting. (
 19 )
NOTE • If DUAL is selected, a menu to select MAIN or SUB appears on
screen when a button on the control panel of the projector or remote control is
pressed. Select the projector that you want to operate. Refer to the examples
below.
- When the 0(18 button is pressed, a menu to select MAIN or SUB is
displayed. If MAIN is selected, EASY MENU or ADVANCED MENU of the
Main projector is displayed.
- When one of the buttons from .(<6721(, )2&86, =220, =220
and /(166+,)7 is pressed, a menu to select MAIN or SUB is displayed. If
MAIN is selected, each menu or dialog of the Main projector is displayed.
- <Only for &3;, &3:; and &3:8>
When the (17(5 button is pressed for three seconds, a menu to select
MAIN or SUB is displayed. If MAIN is selected, the Status Monitor on the
Main Projector can be operated.
• When DUAL is selected for
LAMP MODE, there are operating
restrictions as follows.
- AUTO POWER OFF and
FREEZE functions on both
projectors are disabled.
- The test patterns for CUSTOM of
GAMMA and COLOR TEMP are
not displayed.
- It takes slightly longer time to turn
on the projectors. This is not a
malfunction.
B
0HQXWRVHOHFW
0$,1RU68%
0HQXRQ0DLQSURMHFWRU
B
0HQXWRVHOHFW
0$,1RU68%
0HQXRQ0DLQSURMHFWRU
(continued on next page)
3.3 Selecting lamp operation mode
Select the DUAL or ALTERNATE lamp operation mode.
1. Highlight LAMP MODE in the STACK menu with
the ▲/▼ buttons, then press the ► button to
display the LAMP MODE dialog.
2. Use the ▲/▼ buttons in the dialog to highlight DUAL or ALTERNATE.
'8$/: Turns on the projectors at the same time.
$/7(51$7(: Turns on the projectors alternately.