12
Turning off the power
1.
Press the STANDBY/ON button on the
projector or the STANDBY button on
the remote control.
The message “Power off?” will appear
on the screen for about 5 seconds.
2.
Press the STANDBY/ON or STANDBY
button again while the message
appears.
The projector lamp will go off, and the
POWER indicator will begin blinking in
orange. Then the POWER indicator will
stop blinking and light in steady orange
when the lamp cooling is complete.
3.
Attach the lens cover, after the POWER indicator turns to steady orange.
Do not turn the projector on for about 10 minutes or more after turning it off.
Also, do not turn the projector off shortly after turning it on. Such operations might
cause the lamp to malfunction or shorten the lifetime of some parts including the
lamp.
WARNING ►Do not touch around the lamp cover and the exhaust vents
during use or just after use, since it is too hot.
►Remove the power cord for complete separation. The power outlet should
be close to the projector and easily accessible.
NOTE • Please power off the projector after any connected devices are
powered off.
• This projector has the AUTO POWER OFF function that can make the
projector turn off automatically. For more information, please see User’s
Manual - Operating Guide.
POWER indicator
STANDBY
button
STANDBY/ON button
To Next Page
Loading...
