Hitachi CP-X8150 - Resetting All Settings

120
• When the interior portion has become overheated, for safety
purposes, the projector is automatically shut down, and the indicator lamps
may also be turned off. In such a case, disconnect the power cord, and wait at
least 45 minutes. After the projector has sufciently cooled down, please make
conrmation of the attachment state of the lamp and lamp cover, and then turn
the power on again.
NOTE
For the SECURITY indicator, see SECURITY INDICATOR in the SECURITY
menu
(
91).
For the SHADE indicator, see the section "Temporarily shading the screen"
(
36).
The FILTER indicator shows the condition of the air lter. Utilize this feature to
keep the interior of the projector in good condition.
FILTER indicator Description
Turned off
7KHDLU¿OWHULVFOHDQ
No need to clean up.
Lighting In
Orange
7KHDLU¿OWHULVJRLQJWREHFKRNHG
It is recommended to clean it.
Lighting In
Red
7KHDLU¿OWHULVFKRNHG
It is required to turn the power off and clean the air lter
immediately.
Troubleshooting
Regarding the indicator lamps (continued)
Resetting all settings
When it is hard to correct some wrong settings, the FACTORY RESET function
of SERVICE item in OPTION menu (
73) can reset all settings (except settings
such as LANGUAGE, LAMP TIME, FILTER TIME, FILTER MESSAGE, STANDBY
MODE, COMMUNICATION, SECURITY and NETWORK) to the factory default.
• The FILTER indicator might light up in orange or red when something
blocks the intake vents even though the air lter is clean.
• The FILTER indicator might light up differently from other indicators or display
messages related to cleaning the air lter. Follow the prompt that is displayed
earlier.
NOTE