Hitachi CP-X8150 - And Sub Settings

10
Installation
2.4 Confirming Main and Sub settings
NOTE • When Intellectual Stack is in use, only Main is capable of receiving
the remote control signals, Sub will not respond to the remote control signals.
2. The following dialogs appear on the lower right screen.
0DLQ6HWB
6XE6HWA
3. If you press the ► button, the dialog closes and the Main (Set B) menu will
appear when MAIN is highlighted.
If you press the ◄ button, the dialog closes and the menu will disappear.
NOTE • If these dialogs are not displayed on screen, check the RS-232C
connection (

8 ) and the MAIN or SUB setting in the STACK MODE dialog.
(

14 )
1. Press the 0(18 button on the remote control for Main (Set B).