Hitachi CP-X8150 - Connecting Signal Cables; Inputting Image from Main to Sub; Inputting Image to Sub and Main Individually

24
Connecting cables
Inputting image to Sub and Main individually
1.
Split the output signal from your image device into two with device such as a
signal splitter.
2.
Connect the output ports of the image output device to the same input ports
on the Main and Sub projectors.
NOTES for Simple Stack
• &20387(5,1 and ,1 can be used
as the input port for the projector that is
connected with a computer cable at its
021,725287 port. (

Operating Guide
→
SETUP menu) If you wish to use other
input ports, input the image to Sub and Main
individually.
Inputting image from Main to Sub
1.
Connect the 021,725287 port on Main
to the &20387(5,1 port on Sub with a
computer cable.
2.
Connect the image output device to one of
the input ports on Main.
4.2 Connecting signal cables
There are two methods to input image to the Sub projector. (

18, 19 )
- Inputting image from the 021,725287 port on Main to Sub.
- Inputting image to Sub and Main individually.
NOTES for Intellectual Stack
• &20387(5,1 and ,1 can be used
as the input port for the Main projector in
Intellectual Stack. Do not use other ports for
image input.
- You can input component signals to
&20387(5,1 and ,1.
- You can input video signals to the Y pin of
the component video of &20387(5,1 and
,1.
NOTES for Intellectual Stack • /$1, 86%7<3($ and 86%7<3(%
cannot be used as the input ports on the Main projector in Intellectual Stack.
NOTES for Simple Stack • Any of the ports that is compatible with the
signal can be used. Input the same signal to the two projectors individually.
&RQQHFWLRQH[DPSOH
LQ,QWHOOHFWXDO6WDFN
6XE
0DLQ