Hitachi CP-X8800 - Selecting an Input Signal

38
Operating
1.
Press INPUT button on the projector.
Each time you press the button, the projector
switches its input port from the current port as
below.
Selecting an input signal
1.
INPUT button
SHADE
LAN  COMPUTER IN  HDMI 1
VIDEO HDMI 2
SDI*  HDBaseT  DisplayPort
Buttons for input
ports
• If you have set SKIP to some ports from SOURCE SKIP in the
OPTION menu, the input from the ports cannot be selected (87).
• While ON is selected for AUTO SEARCH item in OPTION menu, the projector
will keep checking the ports in above order repeatedly till an input signal is
detected (87).
NOTE
• While ON is selected for AUTO SEARCH item in OPTION menu,
the projector will keep checking every port sequentially till an input signal is
detected (87).
NOTE
Press COMPUTER 1, VIDEO, LAN, HDMI 1 / 2, DisplayPort, HDBaseT or
SDI button on the remote control.
The port corresponding to each button is selected as below.
Button Ports
COMPUTER 1 COMPUTER IN
COMPUTER 2 -
VIDEO VIDEO
LAN LAN
USB TYPE A -
USB TYPE B -
HDMI 1 HDMI 1
HDMI 2 HDMI 2
DisplayPort DisplayPort
HDBaseT HDBaseT
SDI SDI*
DIGITAL -
* CP-WU8700 only