Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(RM)04-03-200]
Rev.0.1
INST(RM)04-03-200
14. Reinstalling the removed parts
If parts were removed in “12. Removing the parts”, reinstall the removed parts.
If parts were not removed, go to Step 15.
(1) Open the handle of the DBPS completely. (Refer to Figure 4-15, Figure 4-16.)
(2) Insert the DBPS into the slot and push it to the end.
(3) Close the handle completely and fix the DBPS.
(4) Install the other DBPS in the same manner.
(5) Keep the right and left levers of the ENC open. (Refer to Figure 4-13, Figure 4-14.)
(6) Insert the ENC until the edge of the lever comes in contact with the Drive Box.
(7) Close the right and left levers to insert the ENC completely.
(8) Install the other ENC in the same manner.
(9) Install the removed parts with the other Drive Boxes in the same manner.
To Next Page
Loading...
