Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(RM)05-01-60]
Rev.0.5
INST(RM)05-01-60
(1) Remove the cable from the Channel Boards to be removed.
(2) Removing Channel Boards.
NOTICE: When removing the Channel Board, hold it with both hands and remove it straight not
to apply a shock to with any components.
Channel Board
Main edge connector
(a) Loosen two screws (blue) fixing the Channel Board to be removed.
(b) Hold the screws (blue) and pull out and remove the Channel Board.
(c) Insert the dummy into the slot to the end from which the Channel Board (CHB) has been
removed.
Figure 5-1 Removing Channel Boards (DKC)
(3) For VSP 5500 and VSP 5500H, repeat the procedure from Step 6 (1) to remove the other Channel
Board.
For VSP 5100 and VSP 5100H, go to Step 7.
Channel Board
Screw (blue)
DKC
Shield Finger
Cable
To Next Page
Loading...
