Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(RM)08-01-110]
Rev.3
INST(RM)08-01-110
(l) <Checking the SVP SHUTDOWN LED>
The message “Is the LED to be removed turned on?” is displayed.
NOTE: Check the status of the SVP SHUTDOWN LED on the Additional SVP (see Figure
8-4).
When the SVP SHUTDOWN LED is on, select [Yes].
Then, go to Step (n).
When the SVP SHUTDOWN LED is not on, select [No].
Then, go to Step (m).
(m) <Removal of SVP>
The message “Check the location of the SVP and remove the SVP. (SVP-OPTION)
After the operation has completed, select [OK].” is displayed.
Go to Step (3).
NOTE: Do not click [OK] in this step.
After completing the procedure for removing the SVP hardware, click [OK].
(n) <Removal of The Additional SVP>
The message “Remove the hardware from the removed part (SVP with the LED on). After the
operation has completed, select [OK].” is displayed.
Go to Step (3).
NOTE: Do not click [OK] in this step.
After completing the procedure for removing the SVP hardware, click [OK].
To Next Page
Loading...
