Copyright © 2019, 2021, Hitachi, Ltd.
DKC910IHitachi Proprietary
[INST(RM)08-01-100]
Rev.0.1
INST(RM)08-01-100
(i) <Start of the remove>
Click [Yes] in response to the message “The SVP and SSVP will be removed. Do you want to
continue?”
The REP LED (red) on the Additional SSVP lights up. (see Figure 8-7)
(j) <The Additional SVP power off>
“Turn off the power supply of the SVP. After the operation has completed, select [OK].” is
displayed.
(k) <Powering off the Additional SVP>
Press the SVP PS ON/OFF switch on the Additional SVP for about one second to power off the
Additional SVP.
Check that the SVP POWER LED on the front of the Additional SVP goes off (see Figure 8-4).
NOTE: If the SVP POWER LED does not go off after about three minutes have passed, press
the SVP PS ON/OFF switch for five seconds or more (forced power-off), and then
check that the SVP POWER LED goes off.
NOTE: If the Additional SVP is powered off, the REP LED (red) on the Additional SSVP
goes off (see Figure 8-7).
Click [OK] in response to the message in Step (j).
To Next Page
Loading...
