11.24 Read Sector(s) (20h/21h)
see below
Status
0 0 1 0 0 0 0 R
Command
- - - - H H H H
Device/Head
1 L 1 D H H H H
Device/Head
V V V V V V V V
Cylinder High
V V V V V V V V
Cylinder High
V V V V V V V V
Cylinder Low
V V V V V V V V
Cylinder Low
V V V V V V V V
Sector Number
V V V V V V V V
Sector Number
V V V V V V V V
Sector Count
V V V V V V V V
Sector Count
see below
Error
- - - - - - - -
Feature
- - - - - - - -
Data
- - - - - - - -
Data
7 6 5 4 3 2 1 0
Register
7 6 5 4 3 2 1 0
Register
Command Block Input
Registers
Command Block Output
Registers
V–0–V0V0V0V0V0V0
ERRIDXCORDRQDSCDFRDYBSYAMNT0NABT0IDN0UNCCRC
0123456701234567
Status RegisterError Register
Figure 130. Read Sector(s) Command (20h/21h)
The Read Sector(s) command reads one or more sectors of data from disk media and then transfers the
data from the device to the host.
The sectors are transferred through the Data Register 16 bits at a time.
If an uncorrectable error occurs, the read will be terminated at the failing sector.
Output parameters to the device
Sector Count The number of continuous sectors to be transferred. If zero is specified,
256 sectors will be transferred.
Sector Number The sector number of the first sector to be transferred. (L=0)
In LBA mode this register contains LBA bits 0 - 7. (L=1)
Cylinder High/Low The cylinder number of the first sector to be transferred. (L=0)
In LBA mode this register contains LBA bits 8 - 15 (Low), 16 - 23 (High). (L=1)
H The head number of the first sector to be transferred. (L=0)
In LBA mode this register contains LBA bits 24 - 27. (L=1)
R The retry bit. This bit is ignored.
Deskstar 180GXP hard disk drive specifications
155
To Next Page
Loading...
Need help?
General