SELECT/WIDE
2
RUNNINGCONTROL
STARTREMOTE
1
FUNC
［× 10h］
ALARM
STR
REMOTE
RUNNINGMODE
AUTOSTART
POWER
LOAD
RESET
SHUTDOWN
STOP
SELECT/WIDE button/light (yellow)
Press to confirm the measurement
values, shutdown history, and
setting status. ( 3.4.1)
To set the ECOMODE [Energy
saving mode] (Fixed speed type
only), hold down the
SELECT/WIDE
button for at least 7 seconds. The
light blinks and ECOMODE is set.
UNLOAD STOP button
STOP button
Stops the compressor
immediately without unloading.
( 3.2.2)
START button
Starts the air compressor.
The START light turns ON while
air compressor is running.
UNLOAD STOP
Press this button to stop the air compressor.
The air compressor will stop after removing the
condensate from the air end.
※This stop button is effective while a stand alone operation.
Stops the compressor in normal state.
The compressor stops running
after removing the condensate
from the air end. ( 3.2.2)
Digital Monitor
Used for basic settings as well
as other various settings in
combination with the LCD monitor.
( 3.3.6)
● ALARM light (green): Blinks
if an alarm failure occurs.
EMERGENCY STOP button
Stops for emergency.
( 3.2.3)
● POWER light (yellow): Lights up when the main
power is turned on.
● REMOTE light (green):
ON (glowing) when the REMOTE button is
pressed in order to activate a remote operation.
ON (blinking) when an external remote-operation-
activation switch has been turned on in order to
activate a remote operation. ( 3.4.6)
● LOAD light (yellow): ON (glowing) when the air
compressor is loading.
● AUTO START light (green):
ON (glowing) while the air compressor is in a stop
due to an AUTO operation,lead/lag operation, or
scheduling operation.
ON (blinking) while the air compressor is in a stop
due to a restartable instantaneous power
interruption. ( 3.3.3)
● SHUTDOWN light (red): Blinks if a shutdown
failure occurs. ( 3.3.3)
RUNNING MODE Light
S
T
O
P
E
M
E
R
G
E
N
C
Y
13
3. OPERATION PROCEDURE [Instrument Panel]
To Next Page
Loading...
Need help?
General
