English
— 21 —
CAUTION
䢇 Check that the main nail stopper and sub
nail stopper slide smoothly by pushing
them with finger.
If not smooth, nails can be driven at an
irregular angle and hurt someone.
4 Lubricate the feeding surfaces of the
nose and the nail guide after cleaning.
This promotes smooth operation and
prevents rust.
3. Cleaning and removal of tar and dirt.
Tar and dirt may build up on the nose
and push lever.
This can prevent correct operation.
Clean and remove tar and dirt with
kerosene, #2 fuel oil or diesel fuel.
NEVER USE GASOLINE or other highly
flammable liquids.
Vapor of such liquids inside the Nailer
could be ignited by a spark produced
during nailing, which can cause an
explosion.
1 Immerse only the area around the
outlet in solvent.
Do not immerse the magazine or
body.
Plastic parts and O-ring may be
damaged.
2 Dry off the Nailer before use. Any oil
film left after cleanup will accelerate
the tar buildup, and the Nailer will
requite more frequent re-cleaning.
3 Make sure the push lever operates
properly.
WARNING
䢇 Never use Nailer unless push lever is
operating properly.
NOTE:
䢇 Solvents sprayed on nose to clean and
free up the push lever may have the
opposite effect. The solvent may soften
the tar on the shingles and cause tar
buildup to be accelerated. Dry operation
is better.
4. Inspecting the magazine
1 DISCONNECT AIR HOSE.
2 Clean the magazine. Remove paper
chips or wooden chips which may
have accumulated in the magazine.
5. Storing
䡬 When not in use for an extended period,
apply a thin coat of the lubricant to the
steel parts to avoid rust.
䡬 Do not store the Nailer in a cold weather
environment.
Keep the Nailer in a warm area.
䡬 When not in use, the Nailer should be
stored in a warm and dry place.
Keep out of reach children.
Nail Guide
Sub Nail Stopper
Feeder Shaft
Feeder
Nose Opening
Main Nail Stopper
Body
Push
Lever
Outlet
Magazine
Nose
01Eng_NV45AB2_US 2/26/09, 11:4621
To Next Page
Loading...
