3 OPERATION
3.1 OPERATION START/STOP
Press “ ” (run/stop). The run indicator will be turned on/off and
the operation will be started or stopped accordingly.
? NOTE
• Once the temperature and air volume settings are entered on the
wired controller, they are applied to the units. The last settings remain
displayed on the controller, being not necessary to set them again.
• When heating operation stops, indoor unit(s) may keep running in Fan
mode for about 2 minutes.
3.2 BASIC OPERATION
1 Wired controller Power ON.
Wait a few seconds to get the controller connected to the
indoor units or to other controller that may be connected to
the same indoor unit.
2 Air Conditioner OFF
When air conditioner is off, press “ ” or “ ” to switch below
items:
“Temperature” ↔ “Mode” ↔ “Fan Speed” ↔ “Menu”.
- Temperature
- Mode
EN
OPERATION
PMML0565 rev.1 - 04/2022
3
To Next Page
Loading...
