3  Press " " to lower the grille until it's lowered to the set 
distance.
•  If it is necessary to further lower the grille (more than the set 
value), press “ ” again.
•  Each press lowers the grille by 20in (50cm).
•  Pressing " " can stop the grille at any position while it is 
lowering.
4  After cleaning the air lter, install the air lter and press " " to 
raise the grille. Once the grille is stored inside the unit, it will 
stop after approximately 3 seconds.
•  If the grille is tilted when stored, press " " again until the tilt 
is corrected.
•  Pressing " " can stop the grille at any position while it is 
raising.
5  Press” ” to return to the indoor unit selection screen. 
To operate other indoor units, perform the operations of 
above Step2. 
To end the operation, press “ ” again to return to the 
“Function Menu” screen. 
•  If there is only one indoor unit, the screen returns to the 
“Function Menu” screen.
5.12 FILTER REMINDER RESET SETTING
This function is used to turn off the lter reminder indication and 
to reset the time of use for the lter.
1  Select “Reset Filter Reminder Time” on the “Function Menu” 
screen and press “OK”. 
2  Press “ ” or “ ” to select “Yes”, and then press “OK”.
•  The screen returns to the "Function Menu" screen depending 
on the type of the indoor unit.
3  Press “OK” and the screen returns to the “Function Menu” 
screen.
EN
FUNCTION MENU
PMML0565 rev.1 - 04/2022
27