Hitachi PC-ARFG-E - 6.1.5 Thermistor Calibration in Controller; 6.1.6 Fan Speed at Cooling Thermo-OFF; NOTE

6.1.5 Thermistor Calibration in Controller
This function is used to calibrate the temperature sensor
embedded into the wired remote controller
The temperature compensation value can be set in 0.5°C
increments within a range of ±3.5°C.
1 Select “Installation Menu” on the Service & Installation
screen and press “OK”.
2 Select “Thermistor Calibration in Controller” setting and
press “OK”.
3 Select the temperature compensation value by pressing “ ”,
“ ” and press “OK”.
4 Press “ ” or “ ” to select “OK “. Press “OK”, the screen
returns to the “Installation Menu”.
6.1.6 Fan Speed at Cooling Thermo-OFF
This function is used to set the fan speed of the indoor unit at
Cooling Thermo-OFF.
1 Select “Fan Speed at Cooling Thermo-OFF”on the
“Installation Menu” screen and press “OK”.
2 Press “ ”, “ ”, “ ” or “ ” to select the indoor unit. Press “OK”.
If there is only one indoor unit connected to the wired remote
controller, this screen is not displayed (the Step3 screen is
shown).
3 If “ ” or “ ” is pressed, the fan speed is selected in the
following order: “Unavailable” ↔ “Low” ↔ “BREEZE”. Select
the fan speed and press “OK” to conrm the setting.
4 Press “ ” to return to the “Installation Menu” screen.
? NOTE
• This menu is a shortcut to set the optional function setting Eb.
• This menu is not allowing to stop the fan during Cooling Thermo OFF.
Refer to the optional function parameters Cd for such option.
EN
SERVICE & INSTALLATION MENU
PMML0565 rev.1 - 04/2022
61