6 Press “ ” and select “Yes”. The address change processing
starts. The result is displayed after a few seconds.
If the address is changed successfully, the word “Completed”
is displayed. Otherwise, the process may have failed. Verify
the settings.
7 When changing multiple indoor units’ address, select
“Continuous” and press “OK”. When nishing, select
“Complete” and press “OK”.
6.1.9 Address Check Operation
This function allows the user to check the addresses of indoor
units when several units are controlled from the same wired
remote controller. Using this function, the user can operate
individually each indoor unit after having selected a specic unit
address.
1 Select “Address Check Operation”on the “Installation Menu”
screen and press “OK”.
2 Press “ ”, “ ”, “ ” or “ ” to select the indoor unit. Press “OK”.
3 Once the indoor unit is selected, press the “ ” button
to operate the unit. Check that the selected address is
matching with the desired indoor unit on the installation.
Once done, press again the “ ” button to stop the unit.
Select another unit and repeat this sequence if necessary.
4 When the air conditioner is OFF, press “ ”, the screen
returns to the “Installation Menu” screen.
EN
SERVICE & INSTALLATION MENU
PMML0565 rev.1 - 04/2022
63
To Next Page
Loading...
