¿ Handling
When
handling loads with fork-lift trucks, special care should be
taken to prevent injury to individuals in the vicinity or damage to the
unit itself.
C A U T I O N
National and
local legislation must be observed with respect
to driving and the handling of loads with fork-lift trucks.
The only places in which the forks of the fork-lift truck can be
inserted are through the openings -A- of the unit base.
Do not apply excessive force to these openings, with either the
forks or other tools. This could damage the base of the unit.
Do not move the unit by pushing it on side -B- of the base with the forks of the fork-lift truck or by applying force on zone
-C-.
Do not use wheelbarrows to move the unit.
¿ Lifting method
Do not remove any of the protective packaging from the unit to
protect it during handling and lifting.
The unit should only be lifted from the base.
Fit the hoisting slings -A- through the openings -B- on the base of
the unit.
D A N G E R
• Always use
textile slings in good condition, without cuts
or wear, and with the correct capacity for lifting the
outdoor unit.
• Do not fit the slings on the wooden base -C- of the unit. The
wooden base is only designed to protect the base of the unit during transportation; it will not withstand the
strain of lifting the unit.
• Do not use metal cables to lift the unit. Metal cables may slip on the wooden base supporting the unit and could
cause the unit to tilt or fall during the lifting operation.
Slightly tighten the two hoisting slings.
Insert protection -E- between where the slings touch the upper
protective cardboard packaging of the the unit. The slings must not
touch the unit.
The slings should form an angle of more than 60° -D- with the upper
part of the unit. The unit should be kept horizontal throughout the
lifting operation. If necessary, tie guide ropes on to prevent the unit
from swinging freely during the lifting process.
Do not apply force to zone -F-.
D A N G E R
No-one should remain in the radius of action of the crane during the lifting process.
2 Unit installation
9
SMGB0065 rev. 1 - 12/2010
2
To Next Page
Loading...
