– 20 –
– 24 –
CANCEL
• By pressing the (PREFERENCE) button during auto, heating, dehumidifying, cooling or stainless plasma
air purifying operation, the air conditioner performs the “Powerful” operation.
• The airflow will be extended so that the air can reach even further during powerful operation.
(Extended Airflow)
Press the (PREFERENCE) button during operation.
• A short beep sounds and the preference (Powerful) operation starts.
(“POWERFUL” indicator lit on the remote controller.)
Press the
(PREFERENCE) button again.
• “POWERFUL” indicator turns off on the remote controller.
Operation mode In this situation
Operating mechanism
Heating
• When you want the room to be
a little warmer
• Set approximately 2°C higher than the preset
temperature. Powerful heating operation is
performed.
Dehumidifying
• When you want the room to be
less humid
• Powerful dehumidifying operation is performed
aiming to achieve humidity of approximately 40%.
Cooling
• When you want a little cooler
air
• When you want the room to be
a little cooler
Auto Dehumidifying
• When you want to remove
humidity a little faster
• Laundry drying efficiency is enhanced.
• Condensation-control efficiency is enhanced.
Dehumidifying
• Set approximately 3°C lower than the preset
temperature. Powerful cooling operation is
performed.
• High speed dehumidifying operation is performed
aiming to achieve humidity of approximately 40%.
Condensation
Control
Quick Laundry
POWERFUL OPERATION
– 25 –
ENGLISH
Please operate with the remote controller. (Moving by hands may cause malfunction.)
Set automatically
• Air conditioner automatically set to the suitable
angle for each operation (Horizontal air deflector
only. The angle of the vertical air deflector is set to
the front). Usually vertical airflow direction control
is not required.
• If room temperature and humidity continue to be
high during cooling, dehumidifying or dry cool
operation, the angle of horizontal air deflector may
change to prevent dripping of condensed water.
Swing
angle
About
60°
Horizontal
About
15°
About
10°
About
50°
Vertical airflow swing
• When the (VERTICAL AIRFLOW) button is pressed,
a short beep sounds and the vertical air deflector repeats
swinging.
• When the air conditioner stops operation, the swing of the
vertical air deflector also stops and the air outlet closes.
• If the operation resumes, the vertical air deflector is
automatically set to the suitable angle for each operation.
• Even if the swing mode is set, the vertical air deflector may
stop swinging depending on the room temperature and
humidity. (Page 27)
(It may take approximately 10 seconds for the air deflector
to start moving. This is due to the checking operation to set
the air deflector to the correct angle.)
Cooling
operation
Heating
operation
Dehumidifying/
Dry Cool operation
Vertical air flow of your preference
• To set the vertical airflow direction to your desired angle, press the (VERTICAL
AIRFLOW) button to move the vertical air deflector, and press the
(VERTICAL
AIRFLOW) button again to stop air deflector at your desired angle.
Press the
(VERTICAL AIRFLOW) button.
• A short beep sounds and the vertical air deflector repeats swinging.
(Vertical airflow swing)
Press the
(VERTICAL AIRFLOW) button again at your preferred angle.
• The swing stops at the position where the button is pressed.
• The air outlet closes if the operation of air conditioner stops. The horizontal air
deflector will be set to your preferred angle when the operation resumes.
• If the operation mode is changed, the horizontal air deflector will automatically be
set to the proper angle suitable for the newly set mode.
ADJUSTING THE VERTICAL AIRFLOW DIRECTION
Do not operate long hours with cooling, dehumidifying, dry operation, airfl ow
swing operation vertical air defl ector in downward state.
Some dew may form on the vertical air defl ector and drop which may wet your
furniture.
CAUTION
To Next Page
Loading...
